Welcome Stranger to OCC!Login | Register

Ultra X2 750 Watt Extreme Edition Modular Review

ajmatson    -   January 14, 2008
» Discuss this article (0)

Lowest Prices

Installation:

Installation of a power supply is one of the easiest component swaps that I have ever done. Before you attempt anything remember to switch off the old power supply and unplug the computer from the wall. For my case, which is the Ultra M998 Mid-Tower Case, you can remove the top panel to gain access to the power supply bay. Unplug and unscrew the old power supply and remove it from the bay.

 

 

 

 

 

 

 

 

Once the old unit is removed, take the Ultra X2 750W EE and slide it into place in the power supply bay. Place the holding screws into the unit making sure it is nice and secure.

 

 

Once the Ultra X2 is secure, take the cables that are required for you system setup, and connect them to the power supply. After you connect them to the Ultra X2, then connect them to the motherboard and devices. Once everything is connected and in place, replace the main power plug to the computer and turn it on. If everything was done correctly all should boot up fine.

 




  1. Introduction & Closer Look
  2. Closer Look (The Power Supply)
  3. Closer Look (The Cables)
  4. Installation
  5. Specifications & Features
  6. Testing
  7. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0268740654