Welcome Stranger to OCC!Login | Register

Enermax Uber Chakra ATX Full Tower

Makaveli    -   April 18, 2007


Lowest Prices

Installation:

Installation was a jiff. The first thing I did, was to install the standoffs, take out the included I/O plate and install my motherboard with its prescribed I/O plate.

 


Next, I installed my video card and PCI cards.


After my motherboard was all set, I installed the power supply.  You simply screw the included plate onto the power supply, then the plate onto the case.


The last thing to do, is to install your hard drives and other bay devices. This was very easy, because you take the rails and snap them into the screw holes on the drive. After they are snapped on, just slide them into the bay where you want them.

 


I did attempt some cable management, but it was really hard as there is no clearance behind the motherboard to hide cables. I also installed a red 120mm fan as an exhaust. Below is a view of the case completely installed and lit up, with the blue LED fan and another shot without it.

 




  1. Introduction & Closer Look
  2. Closer Look Continued (The Case)
  3. Closer Look Continued (Working Components)
  4. Installation
  5. Specifications & Features
  6. Testing
  7. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.1298911572