Tuniq Ensemble 1200W Review
paulktreg - June 30, 2008» Discuss this article (3)
Specifications:
Before we look at the specification table for this power supply, I would just like to discuss general PC power requirements. This power supply, when fully loaded, will pull approximately 13A at 117VAC and approximately 6.25A at 230VAC. This may not seem like much, and to be honest, who's going to fully load one of these monsters, but it all adds up. If like me you have your PC and all peripherals running off one or two extension leads on one wall socket, it could just trip you over the edge. Have a good look at how your PC is getting its power and see if improvements can be made. You'd be surprised how many volts are lost on long cable lengths, especially if the rating of the cable is not high enough.
|
AC Input
|
100 – 240V AC 47 – 63Hz
|
|||||||
|
DC
Terminal
Current (A)
|
DC Terminal Current (A)
|
|||||||
|
12V1
|
12V2
|
12V3
|
12V4
|
5V
|
3.3V
|
-12V
|
+5VSB
|
|
|
20
|
20
|
25
|
25
|
30
|
30
|
0.8
|
6
|
|
|
Max Combined
|
1080W
|
200W
|
9.6W
|
30W
|
||||
|
Total Power
|
1200W |
|||||||
Over/Under Voltage Protection(OVP/UVP)
When the output voltage exceeds the specification below, the power supply shall be latched into the status of shutdown.
|
DC Output
|
UVP(Min)
|
OVP(Max)
|
|
+5V0
|
3.9V
|
7.0V
|
|
+3V3
|
2.8V
|
4.3V
|
|
+12V
|
8.0V
|
15.6V
|
Over Current Protection
Overload current applied to each tested output rail will cause output trip before they reach or exceed 110%-150% for testing purposes. Overload current shall be ramped at a minimum rate of 10A/s starting from full load.
Short Circuit Protestion
When any set of DC output is in short circuit, the power supply shall be latched into status of shutdown in order to protect the circuits and components from being damaged.
Overload Protection
When the total output exceeds 130%-150% of maximum load limit, the power supply shall be latched into the status of shutdown to prevent components from being damaged.
|
Power Supply Weight
|
||
|
Manufacturer/Model
|
Weight
|
|
|
Tuniq Ensemble 1200W
|
3.8kg
|
8.4lbs
|
|
Tuniq Ensemble 1200W Connectors
|
Qty
|
|
20 + 4 Pin ATX Motherboard Connector
|
1
|
|
4 Pin ATX12V Connector
|
1
|
|
8 Pin EPS12V Connector
|
1
|
|
6 Pin PCI-E Connector
|
2
|
|
8 Pin PCI-E Connector
|
2
|
|
SATA Power Connector
|
6
|
|
4 Pin Molex Connector
|
6
|
|
FDD Connector
|
2
|
|
4 Pin + 4 Pin Connector
|
1
|
|
3 Pin Fan
|
1
|
|
8 Pin PCI-E to 6 Pin PCI-E Adaptor Cable
|
1
|
|
4 Pin Molex Y Cable
|
2
|
|
4 Pin Molex to SATA Power Adapter Cable
|
1
|
Features:
- Max efficiency 87%, Average efficiency 86%
- Minimum 82.3% efficiency at 100% load
- Super Quiet Operation (1500RPM M, Noise under 30dBA at 100% load condition)
- Japanese Ripple Capacitor
- Fan Delay-Off Feature (Fan will not stop working until temp below 50)
- 13.5cm 2-Ball Bearing Fan + 8cm Fan
- Active PFC
- 3-year warranty
- 220mm*148mm*85mm
