Welcome Stranger to OCC!Login | Register

Thermaltake Armor A60 Review

airman    -   September 2, 2010
» Discuss this article (1)

Lowest Prices

Testing:

To test the Thermaltake A60, temperatures will be recorded for the CPU, GPU, chipset, hard drives, and the overall system temperature during load and idle phases. Load will be simulated by Prime95 small FFTs and HD Tune for one hour with maximum temperatures recorded by RealTemp. The GPU load will be the maximum value recorded by RivaTuner after five loops of 3DMark06’s Canyon Flight test. Each case is tested as is from the factory, including the fan configuration. As stated earlier, the fan configuration for the A60 is 1x120mm front intake, 1x120mm rear exhaust, and 1x200mm top exhaust.

Testing Setup:

Comparison Cases:


 

 

 

 

 

 

 

 

 

 

 

The Thermaltake Armor A60 performed just as I expected. The temperatures are right on par with the Armor A90, though being that it is a smaller case, it fell behind by a few degrees in some tests. However, the Armor A60 surpassed the Armor A90 in CPU and GPU idle, though it did fall out to be a bit higher on the chipset temperatures. On the next page, I will wrap up my thoughts about this case.




  1. Introduction & Closer Look
  2. Closer Look (The Case)
  3. Closer Look (Working Components)
  4. Specifications & Features
  5. Testing & Setup
  6. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0250370502