Welcome Stranger to OCC!Login | Register

Turtle Beach Video Advantage PCI

robgs    -   September 13, 2007
» Discuss this article (1)

Installation: Hardware

Next, route the cables through your computer to the opening of your spare 5.25” bay.

 

 

 

 

Included in the parts list is a small set of metal brackets. These brackets are to extend the front connection panel for deeper drive bays. To install these plates, just use the supplied screws and attach the extensions to the back of the panel.

 

 

The next part task is to install the front connector panel into the spare 5.25” bay. Connect the cables that you just routed through your computer to the connection points on the back of the panel. Then slide the panel into the bay and install the mounting screws into the side of the panel.

 

 

Finally, replace all of the side covers and the front bezel to your computer and we are now ready to install the driver and software.




  1. Introduction & Closer Look
  2. Installation: Software Part 1
  3. Installation: Hardware
  4. Installation: Hardware Continued
  5. Installation: Software Part 2
  6. Configuration
  7. Configuration Continued
  8. Testing
  9. Testing Continued
  10. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0298550129