Razer Barracuda HP1 Gaming Headphone Review

Former staff writer - September 19, 2006

There are two ways to install the headphones. One method is plugging the Razer HD-DAI™ (High Definition-Dedicated Audio Interface) plug into the Razer AC-1 Audio Gaming Card (not shown at time of writing due to later release date) and another way is by using your Audio Splitter Cable and inserting the plugs into your analog sound card.

Now all that remains is plugging everything into your computer.

Specfications

Specifications:
8 Discrete Drivers: 6 for Mid-High Frequency, 2 for Bass.
Individual Channel Volume Control / 1 Master Volume Control.
Detachable Microphone.
6 Channel Analog Inputs.
Eight Amplifiers contained within its volume control units.
Output power of 330mW.
Razer HD-DAI™ (High Definition-Dedicated Audio Interface).
99% Oxygen-Free Cable.

Technical Specifications:

Frequency Response	1.50 Hz ~ 20 000Hz
Impedance	1.a. Front Speaker : 64ohm b. Rear Speaker : 32ohm c. Centre Speaker: 64ohm d. Sub-Woofer : 8ohm
Total RMS Power Rating	330mWatts
Cable Length	2 meter
Connector plug	Razer HD-DAI™