Welcome Stranger to OCC!Login | Register

Patriot Extreme Performance 2GB PC2-9200 DDR2-1150MHz Review

ajmatson    -   December 2, 2007
» Discuss this article (0)

Lowest Prices

Installation:

To install the modules, first and most important, make sure all power is off and disconnected. Slide back the retention clips from the old memory and carefully remove them from the memory slots on the motherboard. Now comes the good part. Take the new memory modules and line them up correctly, making sure the notch in the memory slot matches up with the groove on the memory module. Carefully press on the two ends of modules until they snap into place and the retention clips click into place. Viola, all installed. Now just plug back in the power plugs and turn the computer on. Boot into Windows, and there you go, all upgraded and ready to go.

 

 

 

  

 

 

 

If you have a motherboard that supports EPP RAM, at the bios bootup it will show the RAM is detected, and adjust the speeds and timings according to the speed of the RAM.

 

Specifications:

 

Brand
Patriot
  Series
EP
Model
PDC22G9200ELK
Type
240Pin DDR2 SDRAM
Capacity
2GB(1x2GB)
Speed
DDR2 1150(PC9200)
Cas Latency
5
Timings
5-5-5-12
Voltage
2.3v
Modules
256Mx64

 

Features:

  • Patriot Aluminum Bladed heat shield Technology to improve module stability
  • RoHS Compliant
  • EPP Ready
  • Enhanced Latency
  • 100% Tested and Verified
  • BTT Tested to endure maximum performance



  1. Introduction & Closer Look
  2. Installation & Specifications
  3. Testing: CPU-Z, TaskManager
  4. Testing: PCMark05, Sandra
  5. Testing: Cachemem, Far Cry
  6. Overclocking: Results and Testing
  7. Overclocking: PCMark05, Sandra
  8. Overclocking: Cachemem, Far Cry
  9. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0335669518