Welcome Stranger to OCC!Login | Register

NZXT Sentry Temperature Controller

robgs    -   June 18, 2007
» Discuss this article (2)

Installation:

Now that the probes are installed, it's time to install the faceplate into an empty 5.25” bay.  But before we do that, reconnect the probe harness back to the rear of the face plate.  Now, just secure the faceplate into the bay with the screws provided.  Also, don’t forget to remove the protective plastic from the battery.

 

 

 

 

Once the screen is installed, the rest of the wiring can be hooked up.  One problem that I encountered when installing the wiring, was that the Sentry only has support for 3-wire fan connectors and my HSF uses a 4 pin.  Also, all but one fan on my case use Molex power connectors.  The one fan that uses a 3 pin connector is the side cover fan, which I think is the most important one for cooling the Northbridge.




  1. Introduction & Closer Look
  2. Closer Look (Continued)
  3. Installation
  4. Installation (Continued)
  5. Configuration
  6. Features & Testing
  7. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0322659016