Welcome Stranger to OCC!Login | Register

NZXT Duet Case

robgs    -   May 24, 2007


Installation:

Supplied by NZXT are these fancy schmancy tool less clip on brackets to install the 5.25” components. Just insert the studs of the bracket into the mounting holes on the side of the DVD ROM and push the drive into the bay.

 

 

 

 :

 

We’re almost ready to start this baby up. There are two 3.5” bays to install a floppy drive or hard disk drive. The first is available under the 5.25” bays but I installed the HDD in the side or top bay to keep the bottom bay free if I decide to install a FDD later.

 

 

Now we can reinstall the front bezel being very careful to ensure that all the wiring is kept away from any pinch points.

 

 

Finally the last thing to do is to install all of the cables and wires to their correct position on the motherboard and we can move on to test this compact little case.

 

 




  1. Introduction and Closer Look
  2. Closer Look Continued
  3. Installation
  4. Installation Continued
  5. Specifications and Features
  6. Testing
  7. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0254189968