Mushkin PC2-5300 DDR2 SODIMM 2 X 2 GB Memory
Former staff writer - June 21, 2007» Discuss this article (2)
Installation:
Installing laptop memory is a lot easier then you would imagine. When you flip over your laptop, you will see removable panels. On this laptop, there are two panels - one for the hard drive and the other for memory. Using a small screwdriver remove the screws to expose your memory slots.
Once exposed, you will see the memory is held in by two small arm clips. Gently pull them away from the memory chip and the memory that you are replacing will pop up.
After removing the memory you will be replacing, start with the bottom memory slot and insert the new memory and then press down so it snaps into place. Repeat the same procedure with the next memory chip, then screw the panels back on and you are ready to restart your laptop.
Specifications:
|
Frequency
|
667MHz
|
|
Latency
|
5-5-5-15
|
|
Parity
|
Unbuffered
|
|
Voltage
|
1.8V
|
|
Pins
|
200
|
Denstiy:
