Mushkin HP2-6400 DDR2 800 Mhz (2 x 2GB) Ram

Installation:

To get these modules installed, you will first need to make sure you have all power removed from the motherboard. Next up, remove your old modules by pushing the retaining clips away from the memory, so that the modules can be pulled out. Now for the fun! Guide the modules into the DIMM sockets and push down until the retaining clips swing back into position. Verify that the modules are seated and retaining clips are securely locked into position. Reconnect the interactive devices and power the rig back up, to see what kind of performance these modules are capable of.

Houston we have a problem! Upon restart, I was greeted with a C1 error from the motherboard. Not good! I tested each of the modules one at a time and they worked great. I found that I needed to install one module, then go into the BIOS and enable the EPP settings and reboot. Then I could reboot successfully with both modules in place and see the defined settings for the EPP profile. This was a minor glitch, but nothing too overwhelming. Now we are ready for testing.

If you have a motherboard capable of recognizing EPP profiles, you should see that the memory is detected as SLI ready.

Specifications:

Features:

• Lifetime Limited  Warranty
• Frostbyte Technology
• EPP Programing