Welcome Stranger to OCC!Login | Register

Mushkin 4GB (2 x 2GB) XP2-6400 Memory Review

Makaveli    -   October 29, 2007
» Discuss this article (5)

Installation:

To install the Mushkin 4GB XP2-6400 set of RAM, you’re going to have to first power down your computer, take off the side panel, remove your current RAM, insert the new Mushkin RAM into your DDR2 240-pin slots and secure the RAM with the clips on either side of the slots. After the RAM is inserted, close up your computer and power up your system. Now you’re ready to go! If your motherboard recognizes EPP profiles, it should pick up this RAM and the EPP profile associated with it in your BIOS.

 

 

 

 

 

 

 

 

Specifications:

Frequency 800MHz
Latency 4-4-4-12
Voltage 2.0-2.1V
Module 256Mx64
Parity Unbuffered
Pins 240
Chip 128x8




  1. Introduction & Closer Look
  2. Installation & Specifications
  3. Testing: CPU-Z, Task Manager
  4. Testing: PCMark05, SiSoft Sandra
  5. Testing: Cachemem, Far Cry
  6. Overclocking: Results, PCMark05, SiSoft Sandra
  7. Overclocking: Cachemem, Far Cry
  8. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0264620781