Welcome Stranger to OCC!Login | Register

Kingston HyperX H2O PC3 16000 3x2GB Cas 9 Review

ccokeman    -   September 28, 2010
» Discuss this article (8)

Lowest Prices

Features:

  • JEDEC standard 1.5V ± 0.075V Power Supply
  • VDDQ = 1.5V ± 0.075V
  • 667MHz fCK for 1333Mb/sec/pin
  • 8 independent internal bank
  • Programmable CAS Latency: 5,6,7,8,9,10
  • Posted CAS
  • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
  • Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
  • 8-bit pre-fetch
  • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
  • which does not allow seamless read or write [either on the fly using A12 or MRS]
  • Bi-directional Differential Data Strobe
  • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
  • On Die Termination using ODT pin
  • Average Refresh Period 7.8us at lower then TCASE 85 °C, 3.9us at 85°C < TCASE . 95 °C
  • Asynchronous Reset
  • PCB : Height 1.88" (48.00mm) w/ heatsink, double sided component

 

 

All information courtesy of Kingston @  http://www.kingston.com/hyperx/products/h2o.asp




  1. Introduction & Closer Look
  2. Specifications & Features
  3. Testing: Setup & Overclocking
  4. Testing: PCMark Vantage, SiSoft Sandra 2010
  5. Testing: Geekbench, Super Pi Mod 1.5
  6. Testing: Batman Arkham Asylum
  7. Conclusion:
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0257720947