Cooler Master V8 Reviewgotdamojo06 - October 2, 2008
» Discuss this article (18)
To properly test the Cooler Master V8 CPU Cooler, I will be monitoring the highest temperature of the processor at Idle (little to no CPU usage), and at full load (100% CPU usage). My idle test will be done by running the computer for thirty minutes and recording the maximum temperature during that time. I will be using OCCT:PK to simulate a full load. I will run a torture test for 30 minutes with the mixed (CPU and RAM) mode turned on, and gather the maximum temperature during this time. The temperature monitoring software that I will be using is Real Temp 2.60, as it reads all four cores, documents the maximum temperature for a period until you reset it, and most importantly reads the 45nm processor's temperatures correctly. I will be taking the four highest temperatures that were produced during the test, and report the average of the four cores. The stock test will be done using all of the stock settings for the Q9450 @ 2666MHz. During the overclocked tests, I will be using 410MHz FSB with an 8x multiplier to give me 3280MHz overclocked speed, with a vCore of 1.34v. All of the temperatures are measured in degrees Celsius.
- Processor: Intel Core2 Quad Q9450 (Stock & 3.2GHz)
- Motherboard: Gigabyte GA-X48-DQ6
- Memory: Mushkin Redline XP2 8000 2 x 2 GB 5-5-5-12
- Video Card: Sapphire HD4850
- Power Supply: Mushkin 800w Modular Power Supply
- Hard Drive: Seagate 1TB SATA
- Optical Drive: Lite-on DVD-RW
- Case: Cooler Master Cosmos S
- OS: Windows Vista Ultimate
- Ambient Temperature: 26° Celsius
NOTE: Some of the listed heatsinks were originally tested using an E6600; I recently retested and gathered new data after the switch from the E6600 to the Q9450. The new temperatures are represented in the graphs below.
- Heatsink: Sunbeam Core-Contact Freezer
- Heatsink: ASUS Triton 78
- Heatsink: Scythe Ninja 2
- Heatsink: ASUS Triton 85
- Heatsink: Scythe Shuriken 120
- Heatsink: Thermalright Ultra 120 Extreme
- Heatsink: Stock Intel C2D 45nm HSF
After carefully testing the Cooler Master V8 CPU Cooler, you can see that it was able to keep about the same temperatures between the overclocked and the stock idle conditions, which let it tie the Thermalright Ultra 120 Extreme during the stock testing. But, when it was overclocked, it was 2° lower than the Thermalright. Cooler Master has done something right with this cooler, as the temperatures were lower than the previous champion, only by 1°, during the overclocked full load testing, but it was 3° higher during the stock full load testing.