Cirago Smart Mobile StoragePropane - August 23, 2007
» Discuss this article (0)
The drive fits well inside of the case, which is held shut with a small Velcro patch. The case is made out of a leather feeling material and has a loop to allow it to be mounted on a belt.
The back of the enclosure pulls off to allow access to the hard drive underneath. The drive is IDE and can be replaced with any 2.5" IDE drive.
Now that all the details of how the device works are out of the way, let's see how it performs!
All that had to be done to completely get the drive ready to roll, was to put 4 small screws in the back plate to keep it shut. If you choose to install your own hard drive, all that is required is a small push into the connector while the drive is set to 'master'. After the bottom is secured, a charge of the battery is all that is left to do before you can start using the drive.
The USB and power plugs are located next to each other on the bottom of the unit. Plugging them in is the same as any other unit you have ever encountered.