Welcome Stranger to OCC!Login | Register

Arctic Cooling Accelero S1 & Turbo Module Review

Makaveli    -   September 26, 2007
» Discuss this article (4)

Installation:

Turbo Module:

To install the Arctic Cooling Turbo Module, all you need to do is line up the fans so that they are horizontally aligned and push them into the Accelero S1. Once they are in, take a small screw driver and push the cable that is in between them down into the fins of the Accelero.

 

 

Plug in the 3-pin female connector into the included converter and plug that into your power supply once the video card is correctly inserted into your motherboard. After everything is completely connected, power your system up and make sure both fans are spinning and that they aren’t caught on anything.

 

Everything is installed on the video card, so let’s test these two products!




  1. Introduction & Closer Look
  2. Closer Look (Continued)
  3. Installation
  4. Installation (Continued)
  5. Specifications & Features
  6. Testing
  7. Conclusion
Random Pic
© 2001-2014 Overclockers Club ® Privacy Policy

Also part of our network: TalkAndroid, Android Forum, iPhone Informer, Neoseeker, and Used Audio Classifieds

Elapsed: 0.0293309689